CE 78 FAST 4 H
Plasterboard joint coat and filler
Setting time 4 hours
ADVANTAGES
- Finishing possible the same day
- Low shrinkage
- Fine joint finish
DESCRIPTION
Product designed for making plasterboard joints. The wide range of setting times available means that it is easily adaptable to different worksite sizes.
Product designed for making plasterboard joints. The wide range of setting times available means that it is easily adaptable to different worksite sizes.
PACKAGING
5 to 25 kg bags on a covered pallet.
5 to 25 kg bags on a covered pallet.
COMPOSITION
Gypsum-based powder plaster , calcium carbonate, resin, and various additives.
The resulting compound is white in colour.
Gypsum-based powder plaster , calcium carbonate, resin, and various additives.
The resulting compound is white in colour.
SUITABLE SUBSTRATES
All types of plasterboard with or without insulation (glass wool, rock wool, polystyrene) with tapered edges and cardboard surfaces.
All types of plasterboard with or without insulation (glass wool, rock wool, polystyrene) with tapered edges and cardboard surfaces.
STORAGE
9 months in unopened original packaging, protected from humidity.
9 months in unopened original packaging, protected from humidity.
SUBSTRATE PREPARATION
The plasterboards are to be fitted in compliance with DTU 25.42
The board cut-outs must be bevelled and dust-free.
The plasterboards are to be fitted in compliance with DTU 25.42
The board cut-outs must be bevelled and dust-free.
MIXING RATIO
10 to 11 litres of water per 25 kg bag.
10 to 11 litres of water per 25 kg bag.
USE
Before dealing with the joints themselves, the joints between accidentally non-joining panels must be filled in and various repairs carried out (spalls, damage to the surface, etc.).
The application is done manually by "buttering" the tapered area with a 10 or 15 cm long coating knife and placing the tape. (Ground side against the coating).
Then make a finishing pass, let dry and finish to mask the tape. Also mask the screw heads.Apply a ceiling angle tape, ensuring that the concrete is free of any traces of formwork oil.
In the case of vertical protruding corners, use a reinforced tape (reinforcement on the complex side) or a steel angle.
Before dealing with the joints themselves, the joints between accidentally non-joining panels must be filled in and various repairs carried out (spalls, damage to the surface, etc.).
The application is done manually by "buttering" the tapered area with a 10 or 15 cm long coating knife and placing the tape. (Ground side against the coating).
Then make a finishing pass, let dry and finish to mask the tape. Also mask the screw heads.Apply a ceiling angle tape, ensuring that the concrete is free of any traces of formwork oil.
In the case of vertical protruding corners, use a reinforced tape (reinforcement on the complex side) or a steel angle.
APPLICATION TIP
To avoid "linting", do not sand the plasterboard cardboard surface before applying a primer.
To avoid "linting", do not sand the plasterboard cardboard surface before applying a primer.
DRYING TIME
Repeat application can be done 4 hours after the first pass.
Repeat application can be done 4 hours after the first pass.
CONSUMPTION
Approx. 350 g/m² of board.
Approx. 350 g/m² of board.
COVERING
Undercoat for plasterboards.
Gypsum-based smoothing compound.
Undercoat for plasterboards.
Gypsum-based smoothing compound.
Semin on
social media
