CE 78 LIGHT 2H
Lightweight plasterboard joint adhesive
For plasterboard joints
ADVANTAGES
- Fast setting 2h
- Yield equivalent to a 25 kg bag of traditional ce 78
DESCRIPTION
Adhesive coating for making tape joints between plasterboard panels. Its "light" formulation reduces the weight of the bag while maintaining the same performance as a conventional product.
Adhesive coating for making tape joints between plasterboard panels. Its "light" formulation reduces the weight of the bag while maintaining the same performance as a conventional product.
PACKAGING
15 kg bags on a covered pallet.
15 kg bags on a covered pallet.
COMPOSITION
Gypsum, calcium carbonate, lightweight filler, resin, and various additives. The resulting compound is white in colour.
Gypsum, calcium carbonate, lightweight filler, resin, and various additives. The resulting compound is white in colour.
SUITABLE SUBSTRATES
All types of plasterboard with or without insulation (glass wool, rock wool, polystyrene) with tapered edges and cardboard surfaces.
All types of plasterboard with or without insulation (glass wool, rock wool, polystyrene) with tapered edges and cardboard surfaces.
STORAGE
9 months in unopened original packaging, protected from humidity.
9 months in unopened original packaging, protected from humidity.
SUBSTRATE PREPARATION
The board cut-outs must be bevelled and dust-free.
The board cut-outs must be bevelled and dust-free.
MIXING RATIO
9,5 to 1 litres of water per 15 kg bag.
9,5 to 1 litres of water per 15 kg bag.
USE
Before dealing with the joints themselves, the joints between accidentally non-joining panels must be filled in and various repairs carried out (spalls, damage to the surface, etc.). |The application is done manually by "buttering" the tapered area with a 1 or 15 cm long coating knife and placing the tape. (Ground side against the coating). |Then make a finishing pass, let dry and finish to mask the tape. Also mask the screw heads.Apply a ceiling angle tape, ensuring that the concrete is free of any traces of formwork oil. |In the case of vertical protruding corners, use a reinforced tape (reinforcement on the complex side) or a steel angle.
Before dealing with the joints themselves, the joints between accidentally non-joining panels must be filled in and various repairs carried out (spalls, damage to the surface, etc.). |The application is done manually by "buttering" the tapered area with a 1 or 15 cm long coating knife and placing the tape. (Ground side against the coating). |Then make a finishing pass, let dry and finish to mask the tape. Also mask the screw heads.Apply a ceiling angle tape, ensuring that the concrete is free of any traces of formwork oil. |In the case of vertical protruding corners, use a reinforced tape (reinforcement on the complex side) or a steel angle.
APPLICATION TIP
To save time on your worksite, don't forget to prepare joint tapes cut to the right length.
To save time on your worksite, don't forget to prepare joint tapes cut to the right length.
DRYING TIME
2h
2h
CONSUMPTION
Approximately 21 g|m² of board (35 g for traditional coating).
Approximately 21 g|m² of board (35 g for traditional coating).
AVAILABLE DOCUMENTATION
DTU 25.41 and DTU 25.42 | NF EN 13963
DTU 25.41 and DTU 25.42 | NF EN 13963
Follow us 
